HP 6125XLG R2306-HP 6125XLG Blade Switch IP Multicast Command Reference - Page 48
multicast routing-enable, reset multicast forwarding-table, Views, Predefined user roles, Examples
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Views System view Predefined user roles network-admin Examples # Configure the device to select the RPF route based on the longest prefix match principle. system-view [Sysname] multicast longest-match multicast routing-enable Use multicast routing-enable to enable IP multicast routing. Use undo multicast routing-enable to disable IP multicast routing. Syntax multicast routing-enable undo multicast routing-enable Default IP multicast routing is disabled. Views System view Predefined user roles network-admin Usage guidelines You must enable IP multicast routing before you can execute other Layer 3 multicast commands. The device does not forward any multicast packets before IP multicast routing is enabled. Examples # Enable IP multicast routing. system-view [Sysname] multicast routing-enable reset multicast forwarding-table Use reset multicast forwarding-table to clear the forwarding entries in the multicast forwarding table. Syntax reset multicast forwarding-table { { source-address [ mask { mask-length | mask } ] | group-address [ mask { mask-length | mask } ] | incoming-interface { interface-type interface-number } } * | all } Views User view 41