HP 6125XLG R2306-HP 6125XLG Blade Switch IP Multicast Command Reference - Page 99
timer hello (PIM view
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
In an ACL, the source field specifies the multicast group range to which the static RP is designated. If you specify a VPN instance in the ACL, the ACL does not take effect. The other optional parameters except the fragment keyword and the time-range keyword are ignored. When the ACL rules referenced by a static RP change, new RPs must be elected for all multicast groups. You can configure multiple static RPs by using this command multiple times. However, if you specify the same static RP address or reference the same ACL in the command, the most recent configuration takes effect. If you configure multiple static RPs for the same multicast group, the static RP with the highest IP address is used. Examples # Configure the interface with the IP address of 11.110.0.6 as a static RP for the multicast groups 225.1.1.0/24, and give priority to this static RP when conflicts exist between static and dynamic RPs. system-view [Sysname] acl number 2001 [Sysname-acl-basic-2001] rule permit source 225.1.1.0 0.0.0.255 [Sysname-acl-basic-2001] quit [Sysname] pim [Sysname-pim] static-rp 11.110.0.6 2001 preferred Related commands display pim rp-info timer hello (PIM view) Use timer hello to set the global interval for sending hello messages. Use undo timer hello to restore the default. Syntax timer hello interval undo timer hello Default The global interval for sending hello messages is 30 seconds. Views PIM view Predefined user roles network-admin Parameters interval: Sets the interval (in seconds) for sending hello messages, in the range of 0 to 18000. A value of 0 means that no hello messages are sent. Usage guidelines You can set the interval for sending hello messages in PIM view or interface view. The configurations made in PIM view are effective on all interfaces, and the configurations made in interface view are effective on only the current interface. If you set the interval in both PIM view and interface view, the configuration in interface view always takes precedence. 93