HP LH4r HP Netserver LC 2000 Installation Guide - Page 127
CD-ROM], Flexible Disk], Hard Drive], Network Boot], Bootable Cards], 30 ID01 LUN0 HP, 26GB A], 30
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Chapter 10 Configuring the HP NetServer 3. Press Enter to change the order and a list appears very similar to the one below: 1. [CD-ROM] 2. [Flexible Disk] 3. [Hard Drive] 4. [Network Boot] The list provides the current boot order of the internal device types, including a NIC in the HP NetServer connected to a network with a boot prom. If the [Hard Drive] selection is moved to the top of the boot list, it will use the logical hard drive selected in Steps 5-6 to boot the system. a. To change the order, use the up- and down-arrow keys to select one of the device types. b. Use the plus (+) or minus (-) keys to move a device type up or down the list. 4. Press Esc to exit one level to the Boot Settings menu. This moves you back one level to the Boot Settings list shown in Step 1 above. 5. To change the hard driver boot order, scroll to "Hard Drive Priority" and press Enter. A hard drive (HD) boot list similar to the one below appears on screen depending on the hard drives and bootable cards (DAC or SCSI Disk Controller) boards installed. The system attempts to boot the NOS on the first hard disk drive (or DAC or SCSI board) found in this list. If no NOS is found, the system tries the next logical hard drive in the list until a NOS is found. 1. [Bootable Cards] 2. [#30 ID01 LUN0 HP 3. [#30 ID02 LUN0 HP 4.26GB A] 4.26GB A] 6. Use the plus (+) or minus (-) keys to move the desired hard drive (or DAC or SCSI board) to the top of the list. ◊ The HD boot list has a maximum capacity of eight (8) logical hard drives. ◊ If a bootable Disk Array Controller (DAC) or SCSI Disk Controller board is used, the board is seen as a single logical drive. 119