HP LH4r HP Netserver LC 2000 Installation Guide - Page 88
Tools Required
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Chapter 8 Rack-Mounting the HP NetServer NOTE If you want to put your NetServer into a third-party rack not mentioned in the guide, you may be able to find relevant documentation on HP's web site at the following URL: http://www.hp.com/netserver/support The HP NetServer rack mount kit requires five EIA units of space in the rack. Before mounting the NetServer, plan the NetServer's location in the rack relative to other rack components. Proper placement is vital both for safety and operating efficiency. For more details, see the HP Rack Installation Road Map and the HP NetServer LC 2000r Rack Cabling Reference Guide. NOTE If the HP NetServer is completely configured by the vendor before delivery to the customer, then mounting the HP NetServer in the rack may be the final step in the installation procedure. If the vendor configures the HP NetServer at the customer's site, installation of the network operating system and other software may occur after the HP NetServer is mounted in the rack. WARNING The HP NetServer weighs 80 lbs. (36 kg) fully loaded. To prevent an accident, use two people when placing the NetServer into the rack. CAUTION If other rack components are to be mounted in the rack below the HP NetServer, install those components before starting to mount the NetServer. Tools Required To assemble the rack mount kit and install the HP NetServer on it, you need these tools. • T-15 and T-25 Torx Drivers • Number 2 Phillips screwdriver l Marking pen 80