HP LH4r HP Netserver LC 2000 Installation Guide - Page 157
See
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
Chapter 13 Alternative Rack Mounting 1. Find the rack-mounting template for the HP Systems rack. If the HP NetServer is still in its box, the template should be in the accessories tray sitting on top of the NetServer itself. 2. Hold the template alongside the outside face (front) of the left front rack column. 3. Line up the bottom of the template with the lower line of space the NetServer will occupy. The template covers a span of 5 EIA units, which is the height requirement of the NetServer. 4. Use the marking pen to mark the 2nd and 14th holes on both front columns, as shown on the template. See Figure 13-2. 5. If you don't have the template, use the markings shown in Figure 13-2 for the column adapters on the front columns. Slide 14th Hole From Bottom Left Front of Rack Column Adapter Column Adapter behind face of front rack column Column Adapter 2nd Hole From Bottom Bottom of HP NetServer Figure 13-2. Rack Nut Placement on Front Rack Columns 6. Place the column adapter mounting holes behind the face (2nd & 14th), and insert two screws (M5) through the holes in the column into the captive nuts on the column adapter. See Figure 13-2. 7. Repeat steps 2 through 6 for the right front rack and tighten all four screws. 149