HP LH4r HP Netserver LC 2000 Installation Guide - Page 161
See
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
Chapter 13 Alternative Rack Mounting Placing the HP NetServer in the Rack Use this topic to place the HP NetServer safely in the rack. The following topics provide instruction for installing the Cable Management Arm and Bezel. WARNING To prevent rack instability while mounting the HP NetServer pull the rack's anti-tip foot forward out of the bottom. Failure to do so could result in injury and equipment damage. To prevent the rack from rolling while you mount the HP NetServer, ensure the leveler screws on the rack's lower four corners are in firm contact with the floor. See Figure 13-6. 1. Lower the leveler screws on the rack's lower four corners to make firm contact with the floor. See Figure 13-6. 2. Ensure you have extended the anti-tip foot from the rack, before continuing this procedure. See Figure 13-6. Mounting Tabs Leveler Screws (4) Slide Members Figure 13-6. Pulling Out the Slides 3. Pull out both slides until the slide members are fully extended. See Figure 13-6. 153