HP LH4r HP Netserver LC 2000 Installation Guide - Page 35
See
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Chapter 3 Opening and Closing the HP NetServer Top Cover Cover Pull Bottom Cover Figure 3-5. Removing HP NetServer LC 2000r Covers 15. If necessary, remove the bottom cover by loosening the thumbscrew at the front of the HP NetServer with one hand. See Figure 3-5. The bottom cover does not provide any additional access to the interior, except the bottom of the mass storage drives and the control panel board. 16. Support the bottom cover with your free hand, as you pull the cover forward to disengage it, catching it as it falls away from the chassis. See Figure 3-5. 17. To replace the top cover, position the cover's tabs over the respective holes along the top edge on both sides of the chassis. 18. Slide the cover toward the rear. 19. Tighten the thumbscrew at the front of the cover. 20. To replace the bottom cover, position the cover's tabs under the respective holes along the bottom edge on both sides of the chassis. 21. Slide the cover toward the rear. 22. Tighten the thumbscrew at the front of the cover. 23. Release the safety latches in the slide members on both sides of the chassis. See Figure 3-4. 27