HP LH4r HP Netserver LC 2000 Installation Guide - Page 59
Installing Non-Hot Swap Storage Devices
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Chapter 4 Installing Mass Storage Devices Installing Non-Hot Swap Storage Devices Use this section to install any of the non-hot swap mass storage devices used as a hard drive or a tape backup storage. CAUTION Protect the drive from static electricity by leaving it in its anti-static bag until you are ready to install it. Before handling the drive, touch any unpainted metal surface to discharge static electricity. When you remove the drive from the anti-static bag, handle it only by the frame. Do not touch the electrical components. Place the drive on the anti-static bag whenever you set it down. Non-Hot Swap Drives (Optional) Figure 4-13. Non-Hot Swap Drive Shelves To install a drive in the non-hot swap drive bay, refer to the following procedure. 1. If necessary, shutdown the HP NetServer's NOS. Refer to Chapter 2, "Controls, Ports, and Indicators." 2. Disconnect all telephone cables and power cords. 51