HP LH4r HP Netserver LC 2000 Installation Guide - Page 65
Covers - Rack Mount LC 2000r in Opening and Closing
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Chapter 5 Installing Additional Memory To install additional memory in the HP NetServer, refer to the following procedure. 1. To gain access to the HP NetServer, perform one of the procedures listed below. NOTE It is not necessary to remove the system board from the HP NetServer to install the additional DIMM memory. ◊ If the NetServer is mounted on the pedestal, perform Steps 1-8 in the "Removing Covers - Pedestal (LC 2000)" in Chapter 3, "Opening and Closing the HP NetServer," to gain access to the NetServer. ◊ If the NetServer is in the rack, perform steps 1-14 in the "Removing Covers - Rack Mount (LC 2000r)" in Chapter 3, "Opening and Closing the HP NetServer," to gain access to the NetServer. 2. Locate the DIMM slot for installation and spread the two retaining clips outward to accept the DIMM. See Figure 5-2. 3. Remove the HP DIMM from its container, handling the module by its edges. If you must lay it down, place it on an anti-static mat. Figure 5-2. Opening Retaining Clips 4. Align the notches on the DIMM with the keys on the DIMM slot, holding the DIMM at a 90° angle to the system board. See Figures 5-2 and 5-3. 57