HP LH4r HP Netserver LC 2000 Installation Guide - Page 74
Removing Covers - Pedestal LC 2000 in Opening
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Chapter 6 Installing Additional Boards 5. Gain access to the NetServer by performing the appropriate procedure for the NetServer LC 2000 or the LC 2000r. ◊ If the NetServer is mounted on the pedestal, perform Steps 1-8 in the "Removing Covers - Pedestal (LC 2000)" in Chapter 3, "Opening and Closing the HP NetServer," to gain access to the NetServer. ◊ If the NetServer is in the rack, perform steps 1-14 in the "Removing Covers - Rack Mount (LC 2000r)" in Chapter 3, "Opening and Closing the HP NetServer," to gain access to the NetServer. 6. Consider the boot priority before installing any accessory boards. See Figure 6-1. If installing a SCSI disk controller board, the controller's priority (BIOS search order for a boot drive) is set by the board's slot location. For details, refer to Boot Priority earlier in this chapter. 7. Identify the desired slot (P1 through P6), before installing the accessory board. See Figure 6-1. 66