HP LH4r HP Netserver LC 2000 Installation Guide - Page 163
See
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
Chapter 13 Alternative Rack Mounting The mounting tabs in the slides should be in position to fit into the openings in chassis. See Figures 13-6 and 13-7. 8. Lower the NetServer onto the slide members. The NetServer's handles will temporarily support the NetServer on the slides. 9. Adjust the NetServer's position on the slides to line up the 6 mounting holes on the side (3 each) of the chassis with the screw holes in the slide members. 10. Insert the flathead screws into the slides'holes at the rear and the panheads screws in the other four places to secure the chassis to the slides. 11. Use a Torx T-15 driver to remove the screws holding the handles to the NetServer. See Figure 13-8. 12. Take the handles off the NetServer and store the handles and screws in a convenient place. The handles can be re-attached whenever you remove the NetServer from the rack. If moving the NetServer elsewhere, always package it with the handles attached. Figure 13-8. Removing the Mounting Handles 155