HP LH4r HP Netserver LC 2000 Installation Guide - Page 128
Clearing CMOS
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Chapter 10 Configuring the HP NetServer ◊ If more than eight logical drives are connected to the HP NetServer, drives 9 and above (including the DAC or SCSI boards and the drives connected to each) will not be recognized by the Setup Utility. ◊ You will not be able to enter the Setup Utility to make changes to these logical drives (including DAC and SCSI boards) during the boot process. ◊ However, these logical hard drives (including DAC and SCSI boards) will be properly recognized and activated by the respective NOS. ◊ For more information about selection guidelines, refer to Information Assistant on the HP NetServer Online Documentation CD-ROM. 7. Press Esc to exit the Hard Drive Priority menu. 8. Press Esc again to exit the Boot Settings menu. 9. Use the right-arrow key to select the Exit menu. 10. Choose "Exit Saving Changes" from the list of exit options, then press Enter. A dialog appears asking you to confirm your decision. 11. Choose "Yes" and press Enter. Then the HP NetServer reboots. Clearing CMOS The Setup Utility does not provide a method of clearing CMOS from within the Utility. To clear the CMOS of the configuration settings, you must use the configuration switch on the system board. 1. Power down the HP NetServer and gain access to the system board. Refer to Chapter 3, "Opening and Closing the HP NetServer." 2. On the system board, reset switch 5, on the configuration switch block, from Off (open) to On (closed). See Figure 10-2. To locate the configuration switch block on the system board, refer to Chapter 6, "Installing Additional Accessory Boards." 120