HP LaserJet M1005 Service Manual - Page 66
Overcurrent/overvoltage, High-voltage power distribution
View all HP LaserJet M1005 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Overcurrent/overvoltage There are two overvoltage devices in this device: ● Fuse F101 provides overcurrent protection for the fusing system circuitry. ● Fuse F102 (110 V devices only) provides overcurrent protection to the device dc power supply circuitry. You can check or replace the fuses by removing the left cover. NOTE If either of these fuses fail, replace the engine power supply. See Power supply on page 91. High-voltage power distribution The high-voltage power supply applies an overlap of dc and ac voltage to the primary charging roller and to the developing roller. This circuit also applies a positive or negative dc voltage to the transfer roller according to the instructions from the engine control unit. This circuit also controls the image density by changing the primary ac voltage and the developing ac bias according to the print density setting. High voltage is disabled when the print-cartridge door is open. The following figure shows this process. 50 Chapter 5 Theory of Operation ENWW