Kyocera TASKalfa 5002i Fax System 12 Operation Guide R4 2016.08 - Page 49

Sending Faxes > Basic transmission procedure 6 Send Start. Press the [Start] key. When scanning finishes, transmission starts. When originals are placed in the document processor After originals placed in the document processor are scanned and stored in the memory, the receiving system is dialed. When originals are placed on the glass surface After originals placed on the glass surface are scanned and stored in the memory, the receiving system is dialed. NOTE When continuous scan is set, you can continue with scanning of a next original after an original on the glass surface has been stored in memory. Every time one page is scanned, you perform an operation to allow continued scanning, and after all the originals have been stored in memory, the receiving system is dialed. Continuous Scan (page 3-27) If there is no response from the other machine when you attempt to send, the machine will automatically redial (auto redial). You can change the number of auto redial attempts. Retry Times (page 8-10) Using redial Redial is a function allowing you to dial the last entered number once again. Use this when the receiving system does not respond when you have tried to send a fax. When you want to send the fax to the same receiving system, select [Recall], and you can call the receiving system you dialed on the destination list. 1 Select [Recall]. 2 Press the [Start] key. The transmission will start. NOTE Recall information is canceled in the following conditions. • When you turn the power off • When you send a next fax (new recall information is registered) • When you log out 3-3