Lexmark W820 Service Manual - Page 116

4025-Finisher Replacement 1. Insert the connectors (P/J 275M,259) and the harnesses of the spring tension 80 and sensor full from the hole on the rear of the H-Tra, and clamp them at four places on the top surface of the H-Tra. 2. Insert the connector (P/J 263) and the harness of the spring tension 80 from the hole on the rear of the H-Tra, and clamp them at seven places on the top surface of the HTra. 3. Clamp the H-Tra harness assembly at four places on the bracket assembly. 4. Clamp the H-Tra harness assembly at one place, and push the latch of that clamp into the hole on the Bracket Assembly with your fingers to mount it. (Figure 2) 5. Plug the connector (P/J 260) of the Sensor. 6. Plug three connectors (P/J 882A,879A,880A) of the Harness Connection, and mount the Harness Connection on the H-Tra harness assembly. 7. Plug the connector (P/J 256M) of the Solenoid Assembly. 8. Mount the Sensor and Sensor. 9. Mount the Sensor. 10. Close the top cover of the H-Tra. 11. Mount the Rear Cover. 4-8 Service Manual