Lexmark W820 Service Manual - Page 152
Roll Transport Removal
UPC - 734646210508
View all Lexmark W820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
4025-Finisher Roll Transport Removal Removal 1. Remove the Cover-Jogging. 2. Remove the Cover-Top, Front and Cover-Top, Rear. 3. Remove the Cover-Open, Front, Cover-Front and Kit Stud Cover. 4. Remove the Cover-Rear. 5. Remove the Cover Top Left. 6. Remove the Top Center Cover Assembly. 7. Remove the Sensor, Input Path. 8. Remove the Kit Drive Assembly. 9. Remove the Bearing that secures the shaft on the front side of the Roll Transport. WARNING: In the following steps, take care not to allow the harness to get stuck to the roller. 10. Lift up the Roll Transport a little, and move it toward the rear so that the leading end of the shaft on the front side enters into the inside of the Finisher frame. 11. Lift up the shaft on the front side of the Roll Transport, and pull it off. 4-44 Service Manual