Lexmark W820 Service Manual - Page 59
Lexmark W820 - Optra B/W Laser Printer Manual
UPC - 734646210508
View all Lexmark W820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Pre-Reg Print cycle Print surface PS PWB R R Reg or Regi R/H ROM RTN S Sensor SG Signal name SNR SOL SOS STA STS SW T Temp Test Print Test Print Mode Toggle Toner Transfer V- V VAC VDC W- Warm-up 4025-Finisher Pre-Registration The printer creating and delivering one finished print The side of a sheet of paper that receives the printed image Power Supply Printed Wiring Board (sometimes referred to as PCB or Printed Circuit Board) Right Registration Right Hand Read Only Memory Return A device used to monitor a function or operation, such as paper travel along the paper path Signal Ground A name assigned to a wire, indicating the purpose of the wire and/or the voltage carried by that wire Sensor Solenoid Start Of Scan Status Soft Touch Sensor Switch Temperature A grid pattern print that is generated by the MCU The mode of operation that lets you generate a test print To switch between two states, such as on and off or up and down The dry ink that is used to create the visible image. Toner is stored in the EP Cartridge Moving the toner image from the surface of the drum to the surface of a sheet of paper Volts Volts - Alternating Current Volts - Direct Current The time it takes the printer to go from main power ON to Ready to Print Introduction 1-47