Lexmark W820 Service Manual - Page 181
Removal, Unplug the connector P/J 5 of the Harness Exit from the Sensor, Exit Path.
UPC - 734646210508
View all Lexmark W820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 181 highlights
4025-Finisher Removal 1. Remove the Cover-Jogging. 2. Remove the Cover-Top, Front and Cover-Top, Rear. 3. Mount the Sensor Assembly. 4. Remove the Kit Shift Motor. 5. Remove the Kit Motor Jogging. 6. Remove the Kit Shift Assembly. 7. Remove the Cover-Rear. 8. Remove the Cover-Open, Front, Cover-Front and Kit Stud Cover. 9. Remove the Compiler Roll and Roll Shaft. 10. Remove the Motor Assembly-MP4. 11. Remove the Kit Gear Front. 12. Remove the Kit Gear Rear. 13. Remove the front and rear E-rings that secure to the Finisher from the Paddle Shaft Assembly, and remove the front and rear Bearing. (Figure 2) 14. Sliding the Paddle Shaft Assembly toward the front until the rear shaft of the Paddle Shaft Assembly enters the rear frame of the Finisher, pull it off in the rear diagonal upward direction. (Figure 2) 15. Remove two E-rings that secure the front and rear sides of the Shaft, and remove the front and rear Bearing. (Figure 3) 16. Unplug the connector (P/J 5) of the Harness Exit from the Sensor, Exit Path. 17. Unplug the connector (CN 43) of the Harness Motor from the Exit Roll. 18. Sliding the Shaft toward the rear until the front shaft of the Shaft enters the front frame of the Finisher, pull off the Kit Compiler Guide in the front diagonal upward direction. 19. Remove four screws that secure to the Finisher from the Kit Shift Assembly. When removing four screws, slide the L Cover of the Kit Shift Assembly to the front or rear where the screws can be seen. 20. Slide the Kit Shift Assembly toward the rear until the end of the Kit Shift Assembly enters the Finisher, and lifting up the front, remove it in a diagonal upward direction. Removal and Replacement Procedures 4-73