Lexmark W820 Service Manual - Page 219

4025-Finisher Cable, Flat Removal Note: Reference the illustrations in the "Sensor Assembly Swing Removal" on page 4-106. Removal 1. Remove the Cartridge. 2. Remove the Bottle Assembly-Dust. 3. Remove the Cover-Jogging. 4. Remove the Cover-Top, Front and Cover-Top, Rear. 5. Remove the Cover-Rear. 6. Remove the Cover-Open, Front, Cover-Front and Kit Stud Cover. 7. Remove the Stapler Assembly 8. Remove the Inner Cover. 9. Remove six screws that secure the Cover Upper Left Assembly to the Finisher frame, and remove the Cover Upper Left Assembly. (Figure 1) 10. Remove the Latch Assembly and Switch Docking. 11. Remove the Stapler Assembly. 12. Unhook the Spring on the back of the stapler. (Figure 2) 13. Slide the small plate toward the front. (Figure 3) 14. Disengage the Belt from the gear to which a driving force is transmitted directly from the Motor Assembly-MP8 on the large frame of the stapler. 15. Turn down the Stapler Assembly together with the small frame of the stapler toward the right. (Figure 3) 16. Remove two screws that secure to the small frame of the stapler from the Cable-Flat. 17. Remove two screws that secure to the large frame of the stapler from the Cable-Flat, and then remove the Cable-Flat. Removal and Replacement Procedures 4-111