Lexmark W820 Service Manual - Page 160

4025-Finisher Removal 1. Remove the Cover-Jogging. 2. Remove the Cover-Top, Front and Cover-Top, Rear. 3. Remove the Cover-Rear. 4. Remove the Cover-Open, Front, Cover-Front and Kit Stud Cover. 5. Unhook the Spring from the hole in the frame on the front of the Finisher. 6. Unhook the Spring from the hole in the frame on the rear of the Finisher. 7. Remove the screw that secures the rear of the Chute-Buffer Assembly. WARNING: In the following steps, the Springs are not secured and easily removed from the shaft of the Chute-Buffer Assembly. Take care not to drop or damage them. 8. Remove the screw that secures the front of the Chute-Buffer Assembly, and remove the Chute-Buffer Assembly together with the Springs toward the front. (Figure 2) 9. Remove two Springs from the shafts of both sides of the Chute-Buffer Assembly. Replacement 1. Insert the Spring into the shaft on the rear of the Chute-Buffer Assembly so that the straight hook is on the inside. (Figure 2) WARNING: In the following steps, the Springs are easily removed from the shafts. Take care not to drop or damage them. 2. From the front, insert the Chute-Buffer Assembly together with the Springs into the inside of the Finisher, and align them with the mounting positions. 3. Secure the front of the Chute-Buffer Assembly together with the Spring with a screw. (Figure 1) 4. Secure the rear of the Chute-Buffer Assembly together with the Spring with a screw. (Figure 1) 5. Hook the Spring to the hole in the frame on the rear of the Finisher with a small screwdriver. 6. Hook the Spring to the hole in the frame on the front of the Finisher with a small screwdriver. 7. Mount the Cover-Open, Front, Cover-Front and Kit Stud Cover. 8. Mount the Cover-Rear. 9. Mount the Cover-Top, Front and Cover-Top, Rear. 10. Mount the Cover-Jogging. 4-52 Service Manual