Lexmark W820 Service Manual - Page 188

4025-Finisher Compiler Roll and Roll Shaft Removal Removal 1. Remove the Cover-Jogging. 2. Remove the Cover-Top, Front and Cover-Top, Rear. 3. Remove the Sensor Assembly. 4. Remove the Sensor, Jogger Home Position. 5. Remove the Kit Motor Jogging. 6. Remove two screws that secure to the Shaft from the Support, and remove the Support. 7. Avoiding the Actuator with your finger, release the Roll Shaft from two bearings of Compiler Guide and remove the Roll Shaft together with two Compiler Rolls. Replacement 1. Avoiding the Actuator with your finger, mount the Roll Shaft together with two Compiler Roll on two bearings of the Compiler Guide. 2. Insert two bosses of Support into the holes in the Compiler Guide, and then align the Shaft to its mounting position so that it pushes the hook of the Spring, then secure with two screws. 3. Mount the Kit Motor Jogging. 4. Mount the Sensor, Jogger Home Position. 5. Mount the Sensor Assembly. 6. Mount the Cover-Top, Front and Cover-Top, Rear. 7. Mount the Cover-Jogging. 4-80 Service Manual