Lexmark W820 Service Manual - Page 117
Transport Gear Kit
UPC - 734646210508
View all Lexmark W820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
4025-Finisher Transport Gear Kit Removal Removal 1. Remove the Rear Cover. 2. Remove the Pulley 2, Spring Tension 80, Sensor and Harness Earth. 3. Remove the Solenoid Assembly-Gate. 4. Remove two screws that secure the Bracket Assembly to the H-Tra, and shift the Bracket Assembly in the arrow direction. 5. Remove two screws that secure the Idler Bracket, and remove the Idler Bracket. 6. Unhook the Spring Gear 250 from the hole in the Support Assembly Gear Idler HT. 7. Unhook the Spring Gear 250 from the hole in the Bracket Assembly, and remove the Spring Gear 250. 8. Remove the E-ring that secures the Gear Idler, Support Assembly Gear Idler HT and Gear Idler L to the shaft of the Bracket Assembly Drive, and then remove the Gear Idler, Support Assembly Gear Idler HT and Gear Idler L. 9. Remove the E-ring that secures the Gear Idler to the shaft of the Support Assembly Gear Idler HT, and remove the Gear Idler. 10. Remove the E-ring that secures the Gear Pulley 32/26 to the shaft of the Bracket Assembly Drive, and remove the Gear Pulley 32/26. 11. Remove two screws that secure the Bracket Assembly Drive to the H-Tra, and remove the Bracket Assembly Drive. Removal and Replacement Procedures 4-9