Lexmark W820 Service Manual - Page 197
Insert the Staple Stage Assembly together with the No Paper Sensor Stapler into
UPC - 734646210508
View all Lexmark W820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 197 highlights
4025-Finisher 17. Release the belt of the Staple Stage Assembly from the gear of the Stack Roll Shaft, and remove the Stack Roll Shaft from the Finisher 18. Disconnect the connector (P/J 13) connector of the No Paper Sensor Stapler attached to the Staple Stage Assembly. 19. Remove the Staple Stage Assembly together with the No Paper Sensor Stapler from the cavity on the front of the Finisher. 20. Remove the screw that secures to the Staple Stage Assembly from the No Paper Align the No Paper Sensor Stapler with the mounting position in the Staple Stage Assembly, and secure it with a screw. Replacement 1. Insert the Staple Stage Assembly together with the No Paper Sensor Stapler into the cavity on the front of the Finisher, insert the gear of the Stack Roll Shaft from the right so that it meshes with the belt of the Staple Stage Assembly, and insert the front of the Stack Roll Shaft into the mounting hole on the front of the Finisher. 2. Connect the connector (P/J 13) of the No Paper Sensor Stapler. 3. Insert the rear of the Stack Roll Shaft into the mounting hole on the rear of the Finisher. 4. Insert the Bearing into the front and rear of the Stack Roll Shaft, and align it with the mounting position. 5. Insert the Gear into the front of the Stack Roll Shaft, and secure the front and rear of the Stack Roll Shaft with an E-ring. 6. Check that the gear of the Stack Roll Shaft meshes with the belt of the Staple Stage Assembly, and secure the front of the Staple Stage Assembly, together with two Spacers, with two Shoulder Screws. 7. Secure the rear of the Staple Stage Assembly with two Shoulder Screws. 8. Mount the Right Cover. 9. Mount the Stapler Assembly. 10. Mount the Bottle Assembly-Dust. 11. Mount the Cartridge. 12. Mount the Compiler Roll and Roll Shaft. 13. Mount the Motor Assembly-MP2. 14. Mount the Motor. 15. Mount the Kit Motor Jogging. 16. Mount the Cover-Rear. 17. Mount the Cover-Open, Front, Cover-Front and Kit Stud Cover. 18. Mount the Cover-Top, Front and Cover-Top, Rear. 19. Mount the Cover-Jogging. Removal and Replacement Procedures 4-89