Lexmark W820 Service Manual - Page 177
Unplug the connector P/J 8 of the Harness Sensor from the Sensor Front.
UPC - 734646210508
View all Lexmark W820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
4025-Finisher Removal 1. Remove the Cover-Jogging. 2. Remove the Cover-Top, Front and Cover-Top, Rear. 3. Remove the Sensor Assembly. WARNING: In the following steps, do not detach the Bracket far away because the connector (P/J 8) of the Sensor (Front) is still connected. 4. Remove the screw that secures the Bracket (Front) to the Finisher, and lift up the Bracket (Front) together with the Sensor (Front). 5. Unplug the connector (P/J 8) of the Harness Sensor from the Sensor (Front). 6. Unhook the Sensor (Front) at three places, and remove the Sensor (Front) from the Bracket (Front). 7. Unplug the connector (P/J 9) of the Harness Sensor from the Sensor (Rear). 8. Remove the screw that secures the Bracket (Rear) to the Finisher, and remove the Bracket (Rear) together with the Sensor (Rear). 9. Unhook the Sensor (Rear) at three places, and remove the Sensor (Rear) from the Bracket (Rear). Replacement Note: In the following steps, the procedure for mounting the Sensor and Bracket on the front is the same as for mounting the ones on the rear. Apply the same procedure to the rear. 1. Insert the connector of the Sensor (Front) into the hole in the Bracket (Front), align the Sensor (Front) with the mounting position in the Bracket (Front), hook it at three places. 2. Plug the connector (P/J 8) of the Harness Sensor to the Sensor (Front). 3. Align the Bracket (Front), together with the Sensor (Front), with the mounting positions in the Finisher, and secure them with a screw. 4. Mount the Sensor Assembly. 5. Mount the Cover-Top, Front and Cover-Top, Rear. 6. Mount the Cover-Jogging. Removal and Replacement Procedures 4-69