Lexmark W820 Service Manual - Page 231
Mount the Drive Assembly-ELEV and Motor Assembly-MD11., Mount the Encorder Assembly.
UPC - 734646210508
View all Lexmark W820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 231 highlights
4025-Finisher Replacement 1. Insert the Shaft ELEV,L a little into the hole on the front of the Finisher, then at the inside of the Finisher, insert the Gear and Encorder Drive Pulley up to the hole on the rear of the Finisher. 2. Insert the Bearing into the front of the Shaft ELEV,L. 3. Insert the Pin into the hole on the front of Shaft ELEV,L, and then insert the Pulley into the Shaft ELEV,L so that the slit of the Pulley is in position. 4. Secure the front of the Shaft ELEV,L with an E-ring. 5. For the rear, perform the above steps (2-4) in the same manner. 6. At the inside of the Finisher, insert the Pin into the hole on the front, and then slide the Gear up to its mounting position so that the slit of the Gear is in position. 7. Secure the front of the Gear with an E-ring. 8. At the inside of the Finisher, insert the Pin into the hole on the rear, and then slide the Encorder Drive Pulley up to its mounting position so that the slit of the Encorder Drive Pulley is in position. 9. Secure the front of the Encorder Drive Pulley with an E-ring. 10. Mount the Holder Assembly. 11. Mount the Encorder Assembly. 12. Mount the Drive Assembly-ELEV and Motor Assembly-MD11. 13. Mount the Right Cover. 14. Mount the Cover-Open, Front, Cover-Front and Kit Stud Cover. 15. Mount the Cover-Rear. 16. Mount the Cover-Top, Front and Cover-Top, Rear. 17. Mount the Cover-Jogging. Removal and Replacement Procedures 4-123