Lexmark W820 Service Manual - Page 196

4025-Finisher Staple Stage Assembly, Stack Roll Shaft, No Paper Sensor Stapler Removal Removal 1. Remove the Cover-Jogging. 2. Remove the Cover-Top, Front and Cover-Top, Rear. 3. Remove the Cover-Open, Front, Cover-Front and Kit Stud Cover. 4. Remove the Cover-Rear. 5. Remove the Kit Motor Jogging. 6. Remove the Motor. 7. Remove the Motor Assembly-MP2. 8. Remove the Compiler Roll and Roll Shaft. 9. Remove the Cartridge. 10. Remove the Bottle Assembly-Dust. 11. Remove the Stapler Assembly. 12. Remove the Right Cover. 13. Remove the E-ring that secure the Bearing and Gear to the front of the Stack Roll Shaft, and remove the Bearing and Gear. 14. Remove the E-ring that secures the Bearing to the rear of the Stack Roll Shaft, and remove the Bearing. 15. Remove the Shoulder Screws on the front that secure the Staple Stage Assembly, together with Spacer, to the Finisher, and remove the Spacers. WARNING: In the following steps, do not detach the Bracket far away because the connector (P/J 13) of the No Paper Sensor Stapler is still connected. 16. Remove the Shoulder Screws on the rear that secure the Staple Stage Assembly to the Finisher. 4-88 Service Manual