Lexmark W820 Service Manual - Page 182

4025-Finisher Replacement 1. Insert the rear of the Kit Shift Assembly into the mounting hole in the frame on the rear of the Finisher. 2. Insert the front of the Kit Shift Assembly into the mounting hole in the frame on the front of the Finisher, and align it with the mounting position. 3. Secure the Frame Assembly-Roll, Shift to the Finisher with four screws. When securing with four screws, slide the sheet metal of the Kit Shift Assembly to the front or rear where the screws can be seen. 4. Insert the shaft on the rear of the Kit Compiler Guide into the hole in the frame on the rear of the Finisher, and insert the shaft on the front of the Shaft into the hole in the frame on the front of the Finisher. 5. Plug the connector (P/J 5) of the Harness Exit to the Sensor, Exit Path. 6. Plug the connector (CN 43) of the Harness Motor to the Exit Roll. 7. Insert two Bearing into the front and rear sides of the Shaft, align them with the mounting positions, and secure them with two E-rings. (Figure 3) 8. Insert the shaft on the front of the Paddle Shaft Assembly into the hole in the frame on the front of the Finisher, and insert the shaft on the rear of the Paddle Shaft Assembly into the hole in the frame on the rear of the Finisher. (Figure 2) 9. Insert the Bearing on the front and rear into the front and rear of the Paddle Shaft Assembly, align them with the mounting positions, and secure them with two E-rings. (Figure 2) 10. Mount the Kit Gear Rear. 11. Mount the Kit Gear Front. 12. Mount the Motor Assembly-MP4. 13. Mount the Compiler Roll and Roll Shaft. 14. Mount the Cover-Open, Front, Cover-Front and Kit Stud Cover. 15. Mount the Cover-Rear. 16. Mount the Kit Shift Assembly. 17. Mount the Kit Motor Jogging. 18. Mount the Kit Shift Motor. 19. Mount the Sensor Assembly. 20. Mount the Cover-Top, Front and Cover-Top, Rear. 21. Mount the Cover-Jogging. 4-74 Service Manual