Lexmark W820 Service Manual - Page 153

4025-Finisher Replacement WARNING: In the following steps, take care not to allow the harness to get stuck to the roller. 1. Let the shaft on the rear side of the Roll Transport through under the harness of the Finisher, and insert it into the bearing on the rear side. 2. Insert the shaft on the front side of the Roll Transport into the bearing on the front side of the Finisher, and secure it with the Bearing. 3. Mount the Kit Drive Assembly. 4. Mount the Sensor, Input Path. 5. Mount the Top Center Cover Assembly. 6. Mount the Cover Top Left. 7. Mount the Cover-Rear. 8. Mount the Cover-Open, Front, Cover-Front and Kit Stud Cover. 9. Mount the Cover-Top, Front and Cover-Top, Rear. 10. Mount the Cover-Jogging. Removal and Replacement Procedures 4-45