Lexmark W820 Service Manual - Page 228

4025-Finisher Shaft Assembly ELEV U Removal Removal 1. Remove the Cover-Jogging. 2. Remove the Cover-Top, Front and Cover-Top, Rear. 3. Remove the Cover-Rear. 4. Remove the Cover-Open, Front, Cover-Front and Kit Stud Cover. 5. Remove the Holder Assembly. WARNING: In the following steps, removing the Pulley allows the Pin to be unsecured and easily removed from the Shaft ELEV, U. Take care not to drop or lose it. 6. Remove the E-ring that secures the Bearing and Pulley on the front to the Shaft ELEV, U, and pull off the Pulley, and then pull the Pin off the hole on the front of the Shaft ELEV, U. 7. Remove the E-ring that secures the Bearing and Pulley on the rear to the Shaft ELEV, U, and pull off the Pulley, and then pull the Pin off the hole on the rear of the Shaft ELEV, U. 8. Remove the front and rear Bearings that secure the Shaft ELEV, U to the Finisher. 9. Pull the Shaft ELEV, U off the Finisher. Replacement 1. Insert the Shaft ELEV, U into the Finisher. 2. Mount the Bearing on the front and rear of the Shaft ELEV, U. 3. Insert the Pin into the hole on the rear of the Shaft ELEV, U and the Pulley into the rear of the Shaft ELEV, U, and secure them with an E-ring. 4. Insert the Pin into the hole on the front of the Shaft ELEV, U and the Pulley into the front of the Shaft ELEV, U, and secure them with an E-ring. 5. Mount the Holder Assembly. 6. Mount the Cover-Open, Front, Cover-Front and Kit Stud Cover. 7. Mount the Cover-Rear, the Cover-Top, Front and Cover-Top. 8. Mount the Cover-Jogging. 4-120 Service Manual