Lexmark W820 Service Manual - Page 254
Unplug the connector CN 37 of the Harness Face Up from the Full Stack Sensor
UPC - 734646210508
View all Lexmark W820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 254 highlights
4025-Finisher Removal 1. Open the Top Center Cover Assembly. 2. Unplug the connector (CN 37) of the Harness Face Up from the Full Stack Sensor Assembly. 3. Disengage two hooks of the connector (CN 37), and pull the connector (CN 37) off from the Finisher Frame. 4. From the rear, disengage two hooks of the Switch Cap, and push the Switch Cap out of the Finisher. 5. Remove two screws respectively on the front and rear that secure the Exit Assembly to the frame. Replacement 1. Align the Exit Assembly with the mounting position in the Finisher, and secure it with two screws respectively on the front and rear. 2. Insert the Switch Cap into the hole in the rear frame, and secure it with two hooks. 3. Insert the connector (CN 37) into the hole in the rear frame, and secure it with two hooks. 4. Plug the connector (CN 37) of the Harness Face Up to the Full Stack Sensor Assembly. 5. Close the Top Center Cover Assembly. 4-146 Service Manual