Sony PDWHD1500 User Manual (PDW-HD1500 Operation Manual for Firmware Version 1 - Page 109
FAM FAM PC REMOTE, net network
View all Sony PDWHD1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Menu items in the 200s, relating to the remote control interface Item number Item name 214 REMOTE INTERFACE 215 i.LINK MODE b) 257 NETWORK ENABLE Settings When the remote control switch is set to REMOTE, select the device from which to remote-control this unit. 9PIN: Device connected to the REMOTE(9P) connector. SDI: Device connected to the SD/HDSDI INPUT connector. i.LINK: Device connected to the (i.LINK) S400 connector. Select the connection method for the (i.LINK) S400 connector. FAM (FAM (PC REMOTE)): FAM connection TS: TS connection Select the remote control switch positions which enable network connections. net (network): Only when the switch is set to "NET". n&9P (network & remote(9PIN)): When the switch is set to "NET", and when the switch is set to "REMOTE" and setup menu item 214 is set to "9PIN". c) a) When the separately sold PDBK-S1500 option is installed. b) When the separately sold PDBK-201 option board is installed c) FTP connections can be made only when the device connected to the REMOTE(9P) connector (D-sub 9 pin) is in stop mode. During FTP connections, the device connected to the REMOTE(9P) connector cannot be used to control this unit. Menu items in the 300s, relating to editing operations Item number Item name 301 VAR SPEED RANGE FOR SYNCHRONIZATION 320 DIGITAL AUDIO PB PROCESS ON EDIT POINT 344 ASSEMBLE AUTO EDIT POSTROLL RECORDING Settings Select the playback speed range when carrying out playback in variable speed mode from a remote control unit connected to the REMOTE(9P) connector. -2~+2: -2 to +2 times normal speed. wide: -2.20 to +2.20 times normal speed. Select the treatment of audio playback at edit points. cut: Carry out a cut (possibly resulting in audio discontinuities at the edit point). fade: Fade out and fade in. Set whether to record 2 seconds of postroll when an additional clip is recorded by sending the AUTO EDIT command (9-pin protocol 20·42) from a nonlinear editing system connected to the REMOTE(9P) connector on the rear panel. Note When using a linear editing system, postroll will not be recorded regardless of this setting. off: Do not record postroll. on: Records approximately 2 seconds of postroll. Menu items in the 400s, relating to preroll Item number Item name Settings 401 FUNCTION MODE AFTER CUE-UP Select the state that the unit goes into after a cuing-up operation. stop: Stops (the stop mode). still: Still playback (in jog and shuttle mode). Item number Item name 501 STILL TIMER Menu items in the 500s, relating to disc protection Settings To protect the disc against shock and vibrations, and to lengthen the life of the laser diodes, the unit automatically enters standby off mode whenever a specified time elapses in a disc stop mode (stop mode or the still picture mode of search mode). This allows you to set the time after which the unit exits a disc stop mode and enters standby off mode. 0.5 s (0.5 sec)... 8 m (8 min)... 30 m (30 min): Can be set in the range from 0.5 seconds to 30 minutes. off: Do not put into standby off mode. Chapter 7 Menus Setup Menu 109