Sony PDWHD1500 User Manual (PDW-HD1500 Operation Manual for Firmware Version 1 - Page 94
Command list, To log out, Standard commands
View all Sony PDWHD1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
Note If you power this unit off during an FTP connection, the data transferred thus far is discarded. To log out To log out after finishing file operations, enter "QUIT" at the command prompt and press the Enter key. Command list The FTP protocol commands supported by this unit include standard commands (see the next section) and extended commands (see page 97). Notes • To execute FTP commands, you must install application software such as PDZ-1 on your computer. • The commands supported by application software vary. • In the command syntax, means a space, entered by pressing the space bar, and means a new line, entered by pressing the Enter key. Standard commands USER Send this command to begin the login process. Command syntax: USER Input example: USER admin PASS After sending the USER command, send this command to complete the login process. Command syntax: PASS Input example: PASS pdw-hd1500 QUIT Terminates the FTP connection. If a file is being transferred, terminates after completion of the transfer. Command syntax: QUIT PORT Specifies the IP address and port to which this unit should connect for the next file transfer (for data transfer from this unit). Command syntax: PORT • h1 (most significant byte) to h4 (least significant byte): IP address • p1 (most significant byte), p2 (least significant byte): Port address Input example: PORT 10,0,0,1,242,48 (IP address: 10.0.0.1, Port number: 62000) PASV This command requests this unit to "listen" on a data port (which is not its default data port). (It puts this unit into passive mode, waiting for the remote computer to make a data connection.) Command syntax: PASV TYPE Specifies the type of data to be transferred. Command syntax: TYPE can be any of the following. However, for XDCAM, data is always transferred as "I", regardless of the type-code specification. • A: ASCII - N: Non-print - T: Telnet format - C: ASA Carriage Control • E: EBCDIC - N: Non-print - T: Telnet format - C: ASA Carriage Control • I: IMAGE (Binary) (default) • L: LOCAL BYTE - SIZE: byte size Input example: TYPE I STRU Specifies the data structure. Command syntax: STRU can be any of the following. However, for XDCAM, the structure is always "F", regardless of the structure-code specification. • F: File structure (default) • R: Record structure • P: Page structure Input example: STRU F MODE Specifies the transfer mode. Command syntax: MODE Chapter 6 File Operations 94 FTP File Operations