Dell 2130 Color Laser User Guide - Page 66

094-911 Contact Support 094-911 IfMessageReturns CRUM ID 093-NNN Reseat XXX Cartridge PHD 091-912 Reseat PHD Shake Cartridge 093-NNN Remove and Shake XXX Cartridge CTD Sensor Dirty 092-310 Clean CTD Sensor Close XXX Cover 077-NNN XXX Cover Is Open Check Paper Size 024-NNN Load XXX xxx Load XXX yyy Out of Memory 016-700 Job too Large Press Disk Full 016-980 Job too Large Press The DTB unit reaches the end of its life. Turn the printer off and then on. If this does not solve the problem, contact Dell. See "Contacting Dell". An unsupported unit is installed. XXX indicates a unit that you replace. Remove the unsupported unit and install a supported one. See "Maintaining Your Printer". The eight yellow ribbons are not correctly removed from the PHD unit. The density of the print cartridge is not enough. XXX is one of the following: Black Cyan Yellow Magenta Ensure that the eight yellow ribbons are correctly removed from the PHD unit. If this does not solve the problem, replace the PHD unit. See "Replacing the Print Head Device (PHD) Unit". Shake the specified toner cartridge five or six times to distribute the toner evenly and reinsert it. The CTD sensor is dirty. Clean the CTD sensor. See "Cleaning the CTD Sensor Inside the Printer". Printer cover is open. XXX indicates printer cover. Close the specified cover. Incorrect paper size is loaded in the specified tray. XXX indicates the number of the tray or single sheet feeder. xxx indicates a paper size. yyy indicates paper quality. Load the specified paper in the specified trays. See "Loading Print Media in the Standard 250-Sheet Tray and Optional 250-Sheet Feeder" and "Loading the Single Sheet Feeder". Press (Set) button to clear the message, cancel the current print job, and conduct the next print job, if any. Press Cancel button to cancel the print job. The printer memory is full and cannot continue processing the current print job. Press Menu button to open Stored Print and delete the holding job. To avoid this error in the future, do the following: Delete unnecessary fonts, macros, and other data in printer memory. Install additional printer memory. See "Printing Held and Proof Print Jobs". Press (Set) button to clear the message, cancel the current print job, and conduct the next print job, if any. Press Cancel button to cancel the print job. Press Menu button to open Stored Print and delete the current job. RAM disk memory is full and cannot continue processing the current print job. To avoid this error in the future, do the following: Reduce the number of print pages such as splitting the print data. Increase free memory space by deleting unnecessary data in the RAM disk. See "Printing Held and Proof Print Jobs".