Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 1062

fefd mode Change the FEFD mode on an interface. E-Series, S4810 Syntax fefd mode {normal | aggressive}] To return the FEFD mode to the default of normal, use the no fefd mode command. Parameters normal aggressive (OPTIONAL) Enter the keyword normal to change the link state to "unknown" when a far-end failure is detected by the software on that interface. When the interface is placed in "unknown" state, the software brings down the line protocol. (OPTIONAL) Enter the keyword aggressive to change the link state to "error-disabled" when a far-end failure is detected by the software on that interface. When an interface is placed in "errordisabled" state, you must enter the fefd reset command to reset the interface state. Defaults Command Modes Command History normal INTERFACE Version 8.3.12.0 Legacy E-Series command. Introduced on the S4810. Related Commands • fefd - enables far-end failure detection. fefd reset Reset all interfaces or a single interface that was in "error-disabled" mode. E-Series, Z-Series, S4810 Syntax Parameters fefd reset [interface] interface (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. 1062