Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 1525

Parameters Defaults Command Modes Command History Related Commands 0-11 S25N|S25P|S25V| S50N|S50V|S4810 Enter a stack member identifier, from 0 to 11, of the switch that you want to add to the stack. Enter the S-Series model identifier of the switch to be added as a stack member. This identifier is also referred to as the provision type. When this value is not set, a switch joining the stack is given the next available sequential stack member identifier. CONFIGURATION Version 7.7.1.0 Introduced on the S-Series. • reload - reboots FTOS. • show system (S-Series) - displays the status of all stack members or a specific member. stack-unit renumber Change the stack member ID of any stack member or a stand-alone S-Series. S-Series Syntax Parameters Defaults Command Modes Command History Usage Information Example stack-unit 0-11 renumber 0-11 0-11 The first instance of this value is the stack member unit identifier, from 0 to 11, of the switch that you want add to the stack. The range is: 0 to 11. The second instance of this value is the desired new unit identifier number. none EXEC Privilege Version 7.7.1.0 Introduced on the S-Series. You can renumber any switch, including the management unit or a stand-alone unit. You cannot renumber a unit to a number of an active member in the stack. When executing this command on the master, the stack reloads. When the members are renumbered, only that specific unit is reset and comes up with the new unit number. FTOS#stack-unit 5 renumber 6 Renumbering will reset the unit. Warning: Interface configuration for current unit will be lost! Proceed to renumber [confirm yes/no]: 1525