Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 786

Example Example (Vlan) Related Commands FTOS(conf-if-vl-10)#untagged gi 7/0 FTOS(conf-if-vl-10)#interface vlan 20 FTOS(conf-if-vl-20)#tagged gi 7/0 FTOS(conf-if-vl-20)# FTOS(conf-if-vl-20)#do show interfaces switchport Name: GigabitEthernet 7/0 802.1QTagged: Hybrid Vlan membership: Vlan 10, Vlan 20 Native VlanId: 10 FTOS(conf-if-vl-20)# FTOS(conf-if-vl-20)#interface vlan 10 FTOS(conf-if-vl-10)#no untagged gi 7/0 FTOS(conf-if-vl-10)#interface vlan 20 FTOS(conf-if-vl-20)#no tagged gi 7/0 FTOS(conf-if-vl-20)#interface gi 7/0 FTOS(conf-if-gi-7/0)#no portmode hybrid FTOS(conf-if-vl-20)# show interfaces switchport - displays the configuration of switchport (Layer 2) interfaces on the switch. switchport - places the interface in a Layer 2 mode. vlan-stack trunk - specifies an interface as a trunk port to the Stackable VLAN network. rate-interval Configure the traffic sampling interval on the selected interface. C-Series, E-Series, S-Series, Z-Series Syntax Parameters rate-interval seconds seconds Enter the number of seconds for which to collect traffic data. The range is 30 to 299 seconds. NOTE: Because polling occurs every 15 seconds, the number of seconds designated here will round to the multiple of 15 seconds lower than the entered value. For example, if 44 seconds is designated, it will round to 30; 45 to 59 seconds will round to 45, and so forth. Defaults Command Modes Command History 299 seconds INTERFACE Version 8.3.11.1 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced on the Z9000. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. 786