Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 240

Defaults Command Modes Command History any host ip-address count byte log dscp order monitor Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host and then enter the IP address to specify a host IP address only. (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL, E-Series only) Enter the keyword log to enter ACL matches in the log. (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values. (OPTIONAL) Enter the keyword order to specify the QoS order of priority for the ACL entry. The range is 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower order numbers have a higher priority). The default is, if you do not use the keyword order, the ACLs have the lowest order by default (255). (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. NOTE: For more information, refer to the "Flow-based Monitoring" section in the Port Monitoring chapter of the FTOS Configuration Guide. fragments Enter the keyword fragments to use ACLs to control packet fragments. Not configured. CONFIGURATION-STANDARD-ACCESS-LIST Version 8.3.11.1 Version 8.3.7.0 Version 8.3.1.0 Version 8.2.1.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 Version 6.5.1.0 Introduced on the Z9000. Introduced on the S4810. Add the DSCP value for ACL matching. Allows ACL control of fragmented packets for IP (Layer 3) ACLs. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Added support for the non-contiguous mask and added the monitor option. Expanded to include the optional QoS order priority for the ACL entry. 240