Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 1623

Parameters Defaults Command Modes Command History Usage Information interface (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For Port Channel interface types, enter the keywords portchannel followed by the number. For the C-Series and SSeries, the range is 1 to 128. For the E-Series, the range is 1 to 255 for TeraScale. • For SONET interfaces, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword FortyGigabitEthernet followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by the VLAN ID. The VLAN ID range is from 1 to 4094. priority-cost (OPTIONAL) Enter a number as the amount to be subtracted from the priority value. The range is 1 to 254. The default is 10. priority cost = 10 VRRP Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on the S-Series (S50 only). Introduced on the C-Series. Introduced on the E-Series. If the interface is disabled, the cost value is subtracted from the priority value and forces a new MASTER election if the priority value is lower than the priority value in the BACKUP virtual routers. virtual-address Configure up to 12 IP addresses of virtual routers in the VRRP group. You must set at least one virtual address for the VRRP group to start sending VRRP packets. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax virtual-address ip-address1 [... ip-address12] To delete one or more virtual IP addresses, use the no virtual-address ipaddress1 [... ip-address12] command. 1623