Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 521

Command History Usage Information Related Commands Version 8.2.1.0 Version 7.4.1.0 Introduced on the E-Series ExaScale. Introduced The E-Series software resolves the network address configured by the network command with the routes in the main routing table to ensure that the networks are reachable via nonBGP routes and non-default routes. redistribute - redistributes routes into BGP. network backdoor Specify this IGP route as the preferred route. C-Series, E-Series Syntax network ipv6-address prefix-length backdoor To remove a network, use the no network ipv6-address prefix-length backdoor command. Parameters ipv6-address prefix-length Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in the /x format. The r range is /0 to /128. NOTE: The :: notation specifies successive hexadecimal fields of zeros. Defaults Command Modes Command History Usage Information Not configured. ROUTER BGPV6-ADDRESS FAMILY Version 8.2.1.0 Version 7.4.1.0 Introduced on the E-Series ExaScale. Introduced Though FTOS does not generate a route due to backdoor config, there is an option for injecting/ sourcing a local route in presence of network backdoor config on a learned route. redistribute Redistribute routes into BGP. E-Series Syntax redistribute {connected | static} [route-map map-name] To disable redistribution, use the no redistribution [connected | static] [route-map map-name] command. Parameters connected Enter the keyword connected to redistribute routes from physically connected interfaces. 521