Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 764

Usage Information Related Commands This command applies only to the Management interface on the route processor modules (RPMs). interface ManagementEthernet - configures the Management port on the system (either the Primary or Standby RPM). duplex (Management) - sets the mode of the Management interface. management route - configures a static route that points to the Management interface or a forwarding router. speed (Management interface) - sets the speed on the Management interface. duplex (10/100 Interfaces) Configure duplex mode on any physical interfaces where the speed is set to 10/100. C-Series, E-Series. S-Series, Z-Series, S4810 Syntax duplex {half | full} To return to the default setting, use the no duplex command. Parameters half full Enter the keyword half to set the physical interface to transmit only in one direction. Enter the keyword full to set the physical interface to transmit in both directions. Defaults Command Modes Command History Not configured. INTERFACE Version 8.3.11.1 Version 8.3.7.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.4.1.0 Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced Usage Information Related Commands This command applies to any physical interface with speed set to 10/100. NOTE: Starting with FTOS version 7.8.1.0, when you use a copper SFP2 module with catalog number GP-SFP2-1T in the S25P model of the S-Series, you can manually set its speed with the speed command. When you set the speed to 10 or 100 Mbps, you can also execute the duplex command. speed (for 10/100/1000 interfaces) - sets the speed on the Base-T Ethernet interface. negotiation auto - enables or disables auto-negotiation on an interface. 764