Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 617

show interface ets Displays the ETS configuration applied to egress traffic on an interface, including priority groups with priorities and bandwidth allocation. S4810 Syntax Parameters show interface port-type slot/port ets {summary | detail} port-type slot/ port ets {summary | detail} Enter the port-type slot and port ETS information. Enter the keyword summary for a summary list of results or enter the keyword detail for a full list of results. Command Modes Command History EXEC Privilege Version 8.3.12.0 Version 8.3.16.0 Introduced on the S4810. Introduced on the MXL 10/40GbE Switch IO Module. Usage Information To clear ETS TLV counters, use the clear ets counters interface port-type slot/port command. The following describes the show interface summary command shown in the Example below. Field Interface Max Supported TC Group Number of Traffic Classes Admin mode Admin Parameters Remote Parameters Local Parameters Description Interface type with stack-unit and port number. Maximum number of priority groups supported. Number of 802.1p priorities currently configured. ETS mode: on or off. When on, the scheduling and bandwidth allocation configured in an ETS output policy or received in a DCBX TLV from a peer can take effect on an interface. ETS configuration on local port, including priority groups, assigned dot1p priorities, and bandwidth allocation. ETS configuration on remote peer port, including admin mode (enabled if a valid TLV was received or disabled), priority groups, assigned dot1p priorities, and bandwidth allocation. If ETS admin mode is enabled on the remote port for DCBX exchange, the Willing bit received in ETS TLVs from the remote peer is included. ETS configuration on local port, including admin mode (enabled when a valid TLV is received from a peer), priority groups, assigned dot1p priorities, and bandwidth allocation. 617