Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 1238

hash-masklength priority Defaults Command Modes Command History Not configured. CONFIGURATION Version 8.3.11.1 Version 8.3.7.0 Version 8.1.1.0 Version 6.1.1.0 • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. (OPTIONAL) Enter the hash mask length. The range is zero (0) to 32. The default is 30. (OPTIONAL) Enter the priority used in Bootstrap election process. The range is zero (0) to 255. The default is zero (0). Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Added support for the VLAN interface. ip pim dr-priority Change the designated router (DR) priority for the interface. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax ip pim dr-priority priority-value To remove the DR priority value assigned, use the no ip pim dr-priority command. Parameters priority-value Enter a number. Preference is given to larger/higher number. The range is 0 to 4294967294. The default is 1. Defaults Command Modes Command History 1 INTERFACE Version 8.3.11.1 Version 8.3.7.0 Version 8.1.1.0 Version 7.8.1.0 Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the C-Series on port-channels and the S-Series. Usage Information The router with the largest value assigned to an interface becomes the designated router. If two interfaces contain the same designated router priority value, the interface with the largest interface IP address becomes the designated router. 1238