Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 829

Example Related Commands {protocol number [icmp/tcp/udp]} {source-port number destination-port number} • Load-balance is configured for IP 5-tuple/3-tuple • An IP payload is going out of a Layer 2 LAG interface that is a member of a VLAN with an IP address FTOS#show port-channel-flow outgoing-port-channel 2 incominginterface gi 3/0 source-ip 2.2.2.0 destination-ip 3.2.3.1 protocol tcp source-port 5 destination-port 6 Egress Port for port-channel 2, for the given flow: Unfragmented packet: Gi 1/6 Fragmented packets (first fragment): Gi 1/12 Fragmented packets (remaining fragments): Gi 1/12 load-balance (E-Series) - balances traffic over E-Series port channel members. Time Domain Reflectometer (TDR) TDR is useful for troubleshooting an interface that is not establishing a link; either it is flapping or not coming up at all. TDR detects open or short conditions of copper cables on 100/1000 Base-T modules. Important Points to Remember • The interface and port must be enabled (configured-refer to the interface command) before running TDR. An error message is generated if you have not enabled the interface. • The interface on the far-end device must be shut down before running TDR. • Because TDR is an intrusive test on an interface that is not establishing a link, do not run TDR on an interface that is passing traffic. • When testing between two devices, do not run the test on both ends of the cable. tdr-cable-test Test the condition of copper cables on 100/1000 Base-T modules. C-Series, E-Series, S-Series, S4810 Syntax Parameters tdr-cable-test interface interface Enter the keyword GigabitEthernet followed by the slot/port information for the 100/1000 Ethernet interface. Defaults Command Modes none EXEC 829