Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 734

show redundancy Display the current redundancy configuration. C-Series, E-Series, S4810 Syntax Command Modes show redundancy • EXEC • EXEC Privilege Command History Version 8.3.12.0 Version 8.1.1.0 Version 7.5.1.0 Version 7.6.1.0 Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the C-Series. Introduced on the E-Series. Usage Information The following describes the show redundancy command shown in the Example below. Field RPM Status Description Displays the following information: • Slot number of the RPM. • Whether the RPM is Primary or Standby. • The state of the RPM: Active, Standby, Booting, or Offline. • Whether the link to the second RPM is up or down. PEER RPM Status RPM Redundancy Configuration Displays the state of the second RPM, if present Displays the following information: • which RPM is the preferred Primary on next boot (the redundancy primary command) • the data sync method configured (the redundancy synchronize command) • the failover type (you cannot change this type; it is softwaredependent). Hot Failover means that the running configuration and routing table are applied on secondary RPM. Fast Failover means that the running configuration is not applied on the secondary RPM until failover occurs, and the routing table on line cards is cleared during failover. • the status of auto booting the RPM (the redundancy disable-auto-reboot command) • the parameter for auto failover limit control (the redundancy auto-failover-limit command) • RPM Failover Record Displays the following information: 734