Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 1315

Related Commands If a Policy QoS is applied on an interface when clear qos statistics is issued, it clears the egress counters in show queue statistics and vice versa. This behavior is due to the values being read from the same hardware registers. The clear qos statistics command clears both the queued and matched byte and packet counters if the queued counters incremented based on classification of packets to the queues because of policy-based QoS. If the queued counters were incremented because of some other reason and do not reflect a matching QoS entry in the CAM, this command clears the matched byte and packet counters only. show qos statistics - displays the QoS statistics. description Add a description to the selected policy map or QoS policy. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax description {description} To remove the description, use the no description {description} command. Parameters description Enter a description to identify the policies (80 characters maximum). Defaults Command Modes Command History none CONFIGURATION (policy-map-input and policy-map-output; conf-qos-policy-in and conf-qospolicy-out; wred) Version 8.3.11.1 Version 8.3.7.0 pre-Version 7.7.1.0 Introduced on the Z9000. Introduced on the S4810. Introduced. Related Commands policy-map-input - creates an input policy map. policy-map-output - creates an output policy map. qos-policy-input - creates an input QoS-policy on the router. qos-policy-output - creates an output QoS-policy on the router. wred-profile - creates a WRED profile. match ip access-group Configure match criteria for a class map, based on the access control list (ACL). C-Series, E-Series, S-Series, Z-Series, S4810 Syntax match ip access-group access-group-name [set-ip-dscp value] To remove ACL match criteria from a class map, use the no match ip access-group access-group-name [set-ip-dscp value] command. 1315