Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 1158

Usage Information The distribute-list out command applies to routes being redistributed by autonomous system boundary routers (ASBRs) into OSPF. It can be applied to external type 2 and external type 1 routes, but not to intra-area and inter-area routes. enable inverse mask By default, FTOS allows you to input the OSPF network command with a net-mask. This command provides a choice between inverse-mask or net-mask (the default). C-Series, E-Series, Z-Series Syntax enable inverse mask To return to the default net-mask, use the no enable inverse mask command. Defaults Command Modes Command History net-mask CONFIGURATION Version 8.3.11.1 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on the Z9000. Introduced on the C-Series. Introduced on the E-Series. fast-convergence This command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid route computation so that convergence takes less time. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax fast-convergence {number} To cancel fast-convergence, use the no fast convergence command. Parameters number Enter the convergence level desired. The higher this parameter is set, the faster OSPF converge takes place. The range is 1 to 4. Defaults Command Modes Command History none. ROUTER OSPF Version 8.3.11.1 Version 8.3.7.0 Version 7.8.1.0 Introduced on the Z9000. Introduced on the S4810. Introduced on all platforms. Usage Information The higher this parameter is set, the faster OSPF converge takes place. NOTE: The faster the convergence, the more frequent the route calculations and updates. This impacts CPU utilization and may impact adjacency stability in larger topologies. 1158