Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 762

Example Related Commands NOTE: You cannot apply dampening on an interface that is monitoring traffic for other interfaces. FTOS(conf-if-gi-3/2)#dampening 20 800 4500 120 FTOS(conf-if-gi-3/2)# clear dampening - clears the dampening counters on all the interfaces or just the specified interface. show interfaces dampening - displays interface dampening information. description Assign a descriptive text string to the interface. C-Series, E-Series, S-Series, Z-Series Syntax description desc_text To delete a description, use the no description command. Parameters desc_text Enter a text string up to 240 characters long. Defaults Command Modes Command History none INTERFACE Version 8.3.11.1 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 Introduced on the Z9000. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Modified for E-Series: Revised from 78 to 240 characters. Usage Information Important Points: • Spaces between characters are not preserved after entering this command unless you enclose the entire description in quotation marks ("desc_text"). • Entering a text string after the description command overwrites any previous text string that you previously configured as the description. • The shutdown and description commands are the only commands that you can configure on an interface that is a member of a port-channel. • Use the show interfaces description command to display descriptions configured for each interface. Related Commands show interfaces description - displays the description field of the interfaces. 762