Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 1625

Usage Information Related Command Version 8.3.8.0 Introduced on the S4810. This command applies to a single interface. When used in conjunction with the vrrp delay reload CLI, the later timer rules the VRRP enabling. For example, if vrrp delay reload is 600 and the vrrp delay minimum is 300: • When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up and configured for VRRP. • When an interface comes up, whether as part of a system reload or an interface reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface. vrrp delay reload - sets the delay time for VRRP initialization after a system reboot. vrrp delay reload Set the delay time for VRRP initialization after a system reboot. Z-Series, S4810 Syntax Parameters vrrp delay reload seconds seconds Enter the number of seconds for the delay. The range is 0 to 900 (0 indicates no delay). Defaults Command Modes Command History 0 INTERFACE Version 9.0.0.0 Version 8.3.8.0 Introduced on the Z9000. Introduced on the S4810. Usage Information Related Command This command applies to all the VRRP configured interfaces on a system. When used in conjunction with the vrrp delay minimum CLI, the later timer rules the VRRP enabling. For example, if vrrp delay reload is 600 and the vrrp delay minimum is 300: • When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up and configured for VRRP. • When an interface comes up, whether as part of a system reload or an interface reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface. You must save the configuration and reload the system for the delay timers to take effect. vrrp delay minimum - sets the delay time for VRRP initialization after a line card reboot. 1625