Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 543

Defaults Command Modes Command History Usage Information local-distance Enter a number to assign to routes learned from networks listed in the network command. The range is 1 to 255. The default is 200. • external-distance = 20 • internal-distance = 200 • local-distance = 200 ROUTER BGPV6-ADDRESS FAMILY Version 7.4.1.0 Introduced CAUTION: Dell Force10 recommends that you do not change the administrative distance of internal routes. Changing the administrative distances may cause routing table inconsistencies. The higher the administrative distance assigned to a route means that your confidence in that route is low. Routes assigned an administrative distance of 255 are not installed in the routing table. Routes from confederations are treated as internal BGP routes. neighbor activate This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI. E-Series Syntax neighbor [ipv6-address | peer-group-name] activate To disable, use the no neighbor [ipv6-address | peer-group-name] activate command. Parameters ipv6-address Enter the IPv6 address in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zeros. peer-group-name activate Identify a peer group by name. Enter the keyword activate to enable the identified neighbor or peer group in the new AFI/SAFI. Defaults Command Modes Command History Disabled. ROUTER BGPV6-ADDRESS FAMILY Version 7.4.1.0 Introduced Usage Information By default, when you create a neighbor/peer group configuration in the Router BGP context, it is enabled for the IPv6/Unicast AFI/SAFI. By using activate in the new context, the neighbor/ peer group is enabled for AFI/SAFI. 543