Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 921

Parameters Defaults Command Modes Command History Usage Information Related Commands prefix-list-name StartingSeqNum Step-toIncrement Enter the name of configured prefix list, up to 140 characters. Increased the name string to accept up to 140 characters. Prior to version 7.8.1.0, the names are up to 16 characters long. Enter the starting sequence number to resequence. The range is 0 to 65535. Enter the step to increment the sequence number. The range is 1 to 65535. none • EXEC • EXEC Privilege Version 8.4.2.0 Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced on the S-Series. Introduced on the E-Series ExaScale. Introduced on the C-Series. Introduced on the E-Series TeraScale. When all sequence numbers have been exhausted, this feature permits re-assigning new sequence number to entries of an existing access-list. resequence access-list - resequences an access-list. seq Assign a sequence number to a deny or permit the filter in an IPv6 access list while creating the filter. C-Series, E-Series, S-Series Syntax seq sequence-number {deny | permit} {ipv6-protocol-number | icmp | ip | tcp | udp} {source address mask | any | host ipv6address} {destination address | any | host ipv6-address} [operator port [port]] [count [byte]] | [log] [monitor] To delete a filter, use the no seq sequence-number command. Parameters sequencenumber deny permit ipv6-protocolnumber Enter a number from 0 to 4294967290. Enter the keyword deny to configure a filter to drop packets meeting this condition. Enter the keyword permit to configure a filter to forward packets meeting this criteria. Enter an IPv6 protocol number. The range is 0 to 255. 921